Page 1 of 1
Where to penetrate the bin
Posted: Sun Feb 11, 2024 3:07 am
by Jonowelt
Hey Gents.
I am about to install a NL battery box in my Legend 50.
Problem is, I have no idea where to take the wire into the bin of the bukkie.
Any top tips that donβt drill the body or compromise the canopy seals ?
Thanks in advance
Re: Where to penetrate the bin
Posted: Mon Feb 12, 2024 10:02 am
by niclemaitre
The access panel to the rear lights?
Re: Where to penetrate the bin
Posted: Mon Feb 12, 2024 4:08 pm
by Jonowelt
Yes I was thinking along those lines. Possibly have to make hole there.
Re: Where to penetrate the bin
Posted: Thu Feb 15, 2024 2:43 am
by Mud Dog
Just bear in mind that wherever you might need to make a hole for wiring, That you fit a rubber grommet so that there won't be chaffing of the insulation over time. The battery cables are quite thick so I would make two separate holes, one for each cable ... you will also get a good seal that way, whereas two cables through the same hole won't seal at all.
Re: Where to penetrate the bin
Posted: Thu Feb 15, 2024 3:34 am
by Jonowelt
Lekka, thanks for the advice. Thinking of using one of those electrical penetrators, the kind with a small βoβ ring. Yes I also thought 1 per wire. Thanks for the reply
Re: Where to penetrate the bin
Posted: Thu Feb 15, 2024 8:58 am
by niclemaitre