First went off to Mikem for a complete new suspension,and after a slight hiccup expertly sorted by Darrel
suspension works very well and comfort level are better
Attachments
20130926_162431.jpg (91.06 KiB) Viewed 6133 times
20130926_162354.jpg (115.9 KiB) Viewed 6133 times
20130926_162316.jpg (119.18 KiB) Viewed 6133 times
20130926_162305_1.jpg (58.44 KiB) Viewed 6133 times
"Every loaf of bread is tragic story of grains that could've become beer, but didn't. - Walter Thornburgh"
"The best cure for Sea Sickness, is to sit under a tree. - Spike Milligan"
Jou suspensie lyk baie mooi.Ek het ook Mikems op my bakkie en is baie gelukkig daarmee.
Het Darrel gekyk of jou voorste as se saddles gelyk is?OP die tweede foto as ek na die vere kyk lyk dit asof die saddle nie gelyk is nie.Ek mag verkeerd wees.
“A BAD DAYS FISHING IS BETTER THAN A GOOD DAYS WORK”
“Do what you do so well, that the people that see you do it, will want to see you do it again,and will bring others to see you do it”
Live Life in the FAST lane.... Forget the past, Embrace the FUTURE!!!! To 4x4 or not to 4x4 thats the question.... IT'S A JEEP ..... You wouldn't understand.... [rimg=206x128]
Removed most of the old paint ,sprayed with 1 K etch primer and then with stone chip paint called Ducol,a place in Krugersdorp that supply motor panels and paint , sell it ,used an stone chip gun for which i paid R120.00 for ,to apply stone chip
Dont know bought vehicle with it in all I khow is it is a 27 spline Gearmax axle with Difflock ,replaced left side shaft
Re: SFA TLC
Hi Maartin,
Jou suspensie lyk baie mooi.Ek het ook Mikems op my bakkie en is baie gelukkig daarmee.
Het Darrel gekyk of jou voorste as se saddles gelyk is?OP die tweede foto as ek na die vere kyk lyk dit asof die saddle nie gelyk is nie.Ek mag verkeerd wees.
Dit was die klein hiccup bracket verkeerd om en saddle nie reguit nie Darrel het saddle reggemaak en twee nuwe springs voor ingesit na net 500km ,alhoewel ek nie dink die springs het seergekry nie ,hulle het voor skokbrekers ook uitgehaal en getoets
mcw wrote:do you have the IFS rear axle in there Martin
Dont know bought vehicle with it in all I khow is it is a 27 spline Gearmax axle with Difflock ,replaced left side shaft
Re: SFA TLC
Hi Maartin,
Jou suspensie lyk baie mooi.Ek het ook Mikems op my bakkie en is baie gelukkig daarmee.
Het Darrel gekyk of jou voorste as se saddles gelyk is?OP die tweede foto as ek na die vere kyk lyk dit asof die saddle nie gelyk is nie.Ek mag verkeerd wees.
Dit was die klein hiccup bracket verkeerd om en saddle nie reguit nie Darrel het saddle reggemaak en twee nuwe springs voor ingesit na net 500km ,alhoewel ek nie dink die springs het seergekry nie ,hulle het voor skokbrekers ook uitgehaal en getoets
Ai weereens oortref Darrel hom met uitstekende diens.Dit bly maar lekker om met hom sake te doen.Mooi so Darrel -du so voort
“A BAD DAYS FISHING IS BETTER THAN A GOOD DAYS WORK”
“Do what you do so well, that the people that see you do it, will want to see you do it again,and will bring others to see you do it”
hi I see you fitted MIKEM suspension....I also need to upgrade my suspension as my one blade on the front of my sfa has broken.OEM is very costly...how does the MIKEM compae in price?thx
hi I see you fitted MIKEM suspension....I also need to upgrade my suspension as my one blade on the front of my sfa has broken.OEM is very costly...how does the MIKEM compae in price?thx
I did this July last year full Mikem suspension, shackles, bushes, springs(comfort pack) ,and Gabriel Safari shocks Approx R12000.00
I i had chosen repairable Bilstein i would have been extra 4500.00 i think .Did not see the need as bakkie is used for trips only
Oupoot01 wrote:hi I see you fitted MIKEM suspension....I also need to upgrade my suspension as my one blade on the front of my sfa has broken.OEM is very costly...how does the MIKEM compae in price?thx
Hentie, jy sal nie beter diens kry as by Darrel(Mikem) nie, ek dink Darrel leef net om sy kliente te sien smile.... sy pryse is ook die beste!!
if you want to change this to recovered , first recover me - and have a relevant picture / foto to prove it !
ADVANCED 4x4 DRIVER COURSES DONE : US 254135 / US 254154
(STILL AWAITING SO-CALLED TETA CERTIFICATION VIA THE SERVICE PROVIDER AFRICAN OFF-ROAD ACADEMY - WHAT A JOKE)
kan nog nie se nie by robot gestop ,enjin gaan staan wil nie weer vat nie ,battery goed engin draai ,lyk noe of daar brandstof of spark is nie .Soek nog die fout
mcw wrote:kan nog nie se nie by robot gestop ,enjin gaan staan wil nie weer vat nie ,battery goed engin draai ,lyk noe of daar brandstof of spark is nie .Soek nog die fout
Martin, the damage to the fuse appears to have been caused by a loose-fitting fuse or loose wire or contact. I think you would be wise to replace the fuse holder as well, otherwise it's going to happen again.
If you pass this was again, we have those holders in stock, otherwise you should be able to get at any auto-electrical shop as well, perhaps even Midas. Just ensure that the fuse is a tight fit and that no water can enter it.
-F_D
White Fang: 1999 2.7i DC Raider 4x4 Bull Dog: 1987 4Y-EFI 2.2 DC 4x4 Pra Dog: 1998 Prado VX 3.4 Hound Dog: 2000 2.7i SC 4x4
One Staffie, One Jack Russell, One Ring Neck Screecher, 17 Fish of questionable heritage
After waiting a while the plates for the front bumper,they arrived last week ,positioned centre piece on vehicle ,will remove bumper on long weekend and hopefully finish it ,side pieces have to bent and molded to fit
Attachments
20140413_123712.jpg (125.06 KiB) Viewed 5204 times
20140413_124845.jpg (126.97 KiB) Viewed 5204 times
Middag aan Hilux manne
Dit is een van die mooiste bumpers wat ek nog vir n sfa gesien het.Hoe gaan jy jou winch monteer en waar gaan jou fairlead pas? Baie mooi werk jy kan regtig trots wees
Groete Hansman&Vaaltyn
Ek sal nou begin om n winch bracket te maak wat agter in die canopy ry wat jy opsit as jy die winch nodig het
sal nog kyk hoe dit gaan werk ,het n paar idees in my kop
Martin
did not have much time this morning to work on Lux but managed to fit new grill and bulbar
need to give it one more coat of Satin Black paint (ran out yesterday) and fit the indicators
Attachments
20140420_162220.jpg (101.98 KiB) Viewed 5114 times
So Martin popped by at the office this morning, and I had the pleasure of seeing the bumper "in the flesh". It even looks better than the photos show. very, very nice indeed!
I was so keen to see it that I forgot to offer him coffee.... Sorry bud.
-F_D
White Fang: 1999 2.7i DC Raider 4x4 Bull Dog: 1987 4Y-EFI 2.2 DC 4x4 Pra Dog: 1998 Prado VX 3.4 Hound Dog: 2000 2.7i SC 4x4
One Staffie, One Jack Russell, One Ring Neck Screecher, 17 Fish of questionable heritage
It is so good to have a wife who knows how to use an sewing machine
some canvas some padding ,some cotton thread ,lots of talent
and some cursing my wife made this for our Engel Fridge
Family_Dog wrote:So Martin popped by at the office this morning, and I had the pleasure of seeing the bumper "in the flesh". It even looks better than the photos show. very, very nice indeed!
I was so keen to see it that I forgot to offer him coffee.... Sorry bud.