3.0 D4D engine into SFA

Discuss modifications on your 1979 to late 1998 SFA 4x4 Hilux here.
Post Reply
SeandbSFA
Newbie
Posts: 3
Joined: Sun Jan 28, 2018 7:29 am
Town: Amanzimtoti
Vehicle: 1997 2.8D DC 4x4 SFA
Real Name: Sean

3.0 D4D engine into SFA

Post by SeandbSFA »

Hi All,

Has anyone out there put a 3.0D4D motor into a SFA body? I have the 97 2.8D 4x4 DC Raider and although the motor is still 100% (at 400 000km) I can get my hands on a good condition 3.0 D4D motor with ECU and I am very tempted to do this conversion for the obvious extra vooma. If there are any hickups or challenges that I should be aware of, and of course good solid advice.

Looking forward to some good feedback.

Thanks
Sean
User avatar
Stef
Monster Truck
Monster Truck
Posts: 3125
Joined: Mon Jan 25, 2010 12:54 pm
Town: Pretoria
Vehicle: '98 LTD
Real Name: Stefan
Club VHF Licence: X107

Re: 3.0 D4D engine into SFA

Post by Stef »

If you could mate the D4D engine to your existing drive train I can't see any major issues. I'd check the input shaft of the current drive train to see if a D4D clutch will fit over the splines, and if there is a bellhousing that would fit

If the engine can't be mated to the existing box I think it will take too many mods to get it to work with a D4D box in the SFA, perhaps then a KZ box & txfer case and possibly both diffs would be the easiest route, provided one could mate that to the D4D engine.

So the feasibility will be dependent on what box would work with both the D4D engine and the SFA diff setup i.e txfer case on the same side (ratios are easy enough to adapt).
User avatar
pietpetoors
Moderator
Moderator
Posts: 10649
Joined: Thu May 17, 2007 9:12 pm
Town: Langebaan
Vehicle: 2.7 Hilux 4x4 DC
Real Name: Pieter
Club VHF Licence: X27
Contact:

Re: 3.0 D4D engine into SFA

Post by pietpetoors »

If you have the ECU and wiring harnass it should be possible.
Think D4D and KZ Blocks are the same so you should be able to fit it to KZ box..... if you can find one.

D4D box has output shafts on the wrong side.
Only Dead Fish Go With The Flow!
Image
1999 Hilux 2.7i 4x4 Raider DC with 3.4 Prado V6. Rear diff-lock, Bull Bar and rock sliders, 31" Cooper ST Maxx, Snorkel, Alu-Canopy, VHF Motorolla radio, West Coast Rust, Mikem Suspension, Ball Joint Spacers in front and Mikem extended shackles at the rear, 25watt LED Spots
SeandbSFA
Newbie
Posts: 3
Joined: Sun Jan 28, 2018 7:29 am
Town: Amanzimtoti
Vehicle: 1997 2.8D DC 4x4 SFA
Real Name: Sean

Re: 3.0 D4D engine into SFA

Post by SeandbSFA »

Thanks very much chaps, all makes sense. I will do some investigating. First prize to mate the D4D to the existing drivetrain. I will keep you posted, and if we go ahead, I will post pics and progress reports for all to enjoy.
User avatar
Riaan Opperman
Newbie
Posts: 2
Joined: Tue Aug 05, 2008 10:48 am
Town: Cradock
Vehicle: Toyota Hilux
Real Name: Riaan Opperman

Re: 3.0 D4D engine into SFA

Post by Riaan Opperman »

I want to do the same to my SFA but getting that D4D to purrr is the problem. With the scratching I have done it seems the you need all the electronics to make it run, coded key box, keys, dash, throttle box etc. With just the engine & ECU you will apparently not get it running.

I hope Im wrong on this because its easy to just get an engine & ECU, less easy to get a written of donor vehicle to scavenge all the bits of.

If the clever peoples can jump in and advise, it will be greatly appreciated

Groetnis


Sent from my iPhone using Tapatalk
User avatar
Stef
Monster Truck
Monster Truck
Posts: 3125
Joined: Mon Jan 25, 2010 12:54 pm
Town: Pretoria
Vehicle: '98 LTD
Real Name: Stefan
Club VHF Licence: X107

Re: 3.0 D4D engine into SFA

Post by Stef »

Eish no...if that is the case just go buy a complete D4D bakkie :think:

Lexus is then still the best bang for your buck, provided you get the proper radiator, sump, bell housing and the D4D clutch
Thabogrobler
Monster Truck
Monster Truck
Posts: 5266
Joined: Sun Aug 19, 2007 10:43 pm
Town: Pretoria
Vehicle: '02 'Lux KZ
Real Name: Thabo
Club VHF Licence: x223
Location: Garsfontein
Contact:

Re: 3.0 D4D engine into SFA

Post by Thabogrobler »

Dwayne here on the forum has sorted the electronic issues - he makes it run without all the coded keys etc.

D4D in am SFA is a great combo@
'02 KZ 'Lux. Cooled. Chipped. Onca'd. Cherished!

If you are a diesel fan, raise your hand.
If you aren't raising your hand, raise your standards!

A 4x4 is merely a machine that enables you to get stuck further away from civilization.
User avatar
Stef
Monster Truck
Monster Truck
Posts: 3125
Joined: Mon Jan 25, 2010 12:54 pm
Town: Pretoria
Vehicle: '98 LTD
Real Name: Stefan
Club VHF Licence: X107

Re: 3.0 D4D engine into SFA

Post by Stef »

Kostes vir so conversion? D4D engine seke weer R40k


Edit: R40k vir D4D enjin op Gumtree....R150k om jou 4.2 Cruiser om te bou na 'n D4D toe http://www.n14x4.co.za/projects/
User avatar
Baasvark
LR4WD, Lockers, Crawler Gears
LR4WD, Lockers, Crawler Gears
Posts: 1376
Joined: Mon Aug 01, 2011 7:45 pm
Town: Virginia
Vehicle: '97 D/C with all the trimmings & 2011 Troopy
Real Name: Shane

Re: 3.0 D4D engine into SFA

Post by Baasvark »

Stef wrote:Kostes vir so conversion? D4D engine seke weer R40k


Edit: R40k vir D4D enjin op Gumtree....R150k om jou 4.2 Cruiser om te bou na 'n D4D toe http://www.n14x4.co.za/projects/
Teen daardie prys hoop ek jy kry 'n nuwe een!

Wonder of die ratkas gaan hou?

Sent from my SM-A720F using Tapatalk

Aint it ironic that "Common Sense" aint so common after all...
User avatar
Stef
Monster Truck
Monster Truck
Posts: 3125
Joined: Mon Jan 25, 2010 12:54 pm
Town: Pretoria
Vehicle: '98 LTD
Real Name: Stefan
Club VHF Licence: X107

Re: 3.0 D4D engine into SFA

Post by Stef »

Dus "vanaf" R40k...
Wil my voorkom of di 1HZ se ratkas di krag kan hanteer as hulle net di engine swop doen,maar R150k is n rowwe prys....

Sent from my S30 using Tapatalk

Thabogrobler
Monster Truck
Monster Truck
Posts: 5266
Joined: Sun Aug 19, 2007 10:43 pm
Town: Pretoria
Vehicle: '02 'Lux KZ
Real Name: Thabo
Club VHF Licence: x223
Location: Garsfontein
Contact:

Re: 3.0 D4D engine into SFA

Post by Thabogrobler »

Stef wrote: Tue Feb 06, 2018 6:51 pm Dus "vanaf" R40k...
Wil my voorkom of di 1HZ se ratkas di krag kan hanteer as hulle net di engine swop doen,maar R150k is n rowwe prys....

Sent from my S30 using Tapatalk
Jip,

N1 was nog nooit beskuldig van enige iets cheap nie!
'02 KZ 'Lux. Cooled. Chipped. Onca'd. Cherished!

If you are a diesel fan, raise your hand.
If you aren't raising your hand, raise your standards!

A 4x4 is merely a machine that enables you to get stuck further away from civilization.
User avatar
Rigger
Low Range 4WD
Low Range 4WD
Posts: 188
Joined: Mon Dec 07, 2015 1:03 pm
Town: George
Vehicle: Toyota Hilux 3.0 S/C 4x4
Real Name: Martiens

Re: 3.0 D4D engine into SFA

Post by Rigger »

Die ratkas in die 1HZ Cruisers is presies dieselfde as die in die 4x4 D4d’s. Dis die R151f box. Dis net die transfer box wat verskil.
User avatar
Stef
Monster Truck
Monster Truck
Posts: 3125
Joined: Mon Jan 25, 2010 12:54 pm
Town: Pretoria
Vehicle: '98 LTD
Real Name: Stefan
Club VHF Licence: X107

Re: 3.0 D4D engine into SFA

Post by Stef »

Nou Quote mnr Grobler my voor ek my tikfout kon reg maak.... :blushing:
Rigger wrote: Tue Feb 06, 2018 10:10 pm Die ratkas in die 1HZ Cruisers is presies dieselfde as die in die 4x4 D4d’s. Dis die R151f box. Dis net die transfer box wat verskil.
OO Ok nie dit geweet nie...
Thabogrobler
Monster Truck
Monster Truck
Posts: 5266
Joined: Sun Aug 19, 2007 10:43 pm
Town: Pretoria
Vehicle: '02 'Lux KZ
Real Name: Thabo
Club VHF Licence: x223
Location: Garsfontein
Contact:

Re: 3.0 D4D engine into SFA

Post by Thabogrobler »

Rigger wrote: Tue Feb 06, 2018 10:10 pm Die ratkas in die 1HZ Cruisers is presies dieselfde as die in die 4x4 D4d’s. Dis die R151f box. Dis net die transfer box wat verskil.
Op die Kz het die output shaft se dikte verskil van die Cruiser s'n - weet nie of dit ook die geval is met die D4D's nie.
'02 KZ 'Lux. Cooled. Chipped. Onca'd. Cherished!

If you are a diesel fan, raise your hand.
If you aren't raising your hand, raise your standards!

A 4x4 is merely a machine that enables you to get stuck further away from civilization.
User avatar
Rigger
Low Range 4WD
Low Range 4WD
Posts: 188
Joined: Mon Dec 07, 2015 1:03 pm
Town: George
Vehicle: Toyota Hilux 3.0 S/C 4x4
Real Name: Martiens

Re: 3.0 D4D engine into SFA

Post by Rigger »

Ja jy is reg. Die output shafts verskil omdat die transfer boxes verskil.
User avatar
Stef
Monster Truck
Monster Truck
Posts: 3125
Joined: Mon Jan 25, 2010 12:54 pm
Town: Pretoria
Vehicle: '98 LTD
Real Name: Stefan
Club VHF Licence: X107

Re: 3.0 D4D engine into SFA

Post by Stef »

Solank die flanges pas is dit seker nie 'n probleem nie, of praat ons vd output shaft van die ratkas af txfer box toe?
SeandbSFA
Newbie
Posts: 3
Joined: Sun Jan 28, 2018 7:29 am
Town: Amanzimtoti
Vehicle: 1997 2.8D DC 4x4 SFA
Real Name: Sean

Re: 3.0 D4D engine into SFA

Post by SeandbSFA »

Thabogrobler wrote: Mon Feb 05, 2018 10:43 pm Dwayne here on the forum has sorted the electronic issues - he makes it run without all the coded keys etc.

D4D in am SFA is a great combo@
Thank you,

Dwayne are you out there?
Post Reply

Return to “1979 to early 1998 Hilux (Gen 3&4 aka SFA 4x4)”