First thing that I learned:
1. There are probably people that can cut 100% straight lines with a Jig-saw, I’m not one of them.
2. Second thing: If you can’t find “spry on glue”, don’t use “contact adhesive glue” to cover wood with carpet.
3. Third thing: Not all “illuminated switches” work on 12v. I knew this ,but didn’t read the spec on the switch before I bought and used them.(very disappointed in myself for this)
So, here are the steps I followed:
1. Measured and cut a piece of cardboard till it fits the curve of the roof lining.
2. Transfer to wood and cut out. Also cut any additional holes needed for the design
3. Make and fit the brackets.
4. Fit the cut-outs to the brackets and make sure it fits as planned.
5. Remove the complete unit from the vehicle, keeping everything intact.
6. Complete the structure of the unit.
7. Remove the brackets and sand everything down till smooth
8. Cover with carpet.
9. Paint.
(I would suggest that if you want to cover or paint anything on the inside, do it before you cover outside. I got this wrong)
10. Fit everything and wire.
11. Test
12. Fit to vehicle.
Just want to mention that I did take out the working parts of the cigarette lighters.
The Red light at the – to be able to switch on a light at the back without waking up the kids.
